Vehicle-grade transparent self-healing encapsulated silicone gel

Product features

JOMS  5606 It is a transparent two-component  self-healing silicone gel, which becomes a special soft  material with buffer and automatic recovery after curing.Used to isolate moisture and other harmful contaminants  from  contacting  the  circuit  board,  and provide an insulator for high voltage. Another use is to provide stress relief to protect circuits and interconnectors from high temperatures and mechanical stress.

1:1 addition molding, strong viscosity

High elongation; excellent flexibility, eliminate

Suitable for potting of various modules and power supplies

mechanical stress

Very low oil permeability after curing, excellent compatibility.

Excellent electrical insulation at high temperature,providing protection against high voltage

Long-term use temperature range -50-200℃

Excellent aging resistance and weather resistance

Excellent waterproof, anti-corrosion,moisture-proof, chemical-resistant properties

Can be used for semiconductor modules, sensors, etc

Typical application

Power  Semiconductor,  electronic sensor,  MEMS  Top  Coating,  Automobile  Ecu  integrated  module  and  other packaging protection IC chips, undersea fiber potting and so on .

Characteristics before curing

Operation process

Weigh A and B components in the ratio of 1:1, mix evenly, and directly inject into the components (or modules) to be potted and protected.

The potted components can be left to stand and can be heated and cured (at 80℃ , it takes about 60 minutes), or they can be cured directly at room temperature, which takes about 24 hours .

Precautions

Vacuum defoaming of AB components after mixing can improve the performance of hardened products

Components A and B should be sealed and stored after being taken

Too low temperature will lead to slow curing speed, it is recommended to heat and cure

JOMS 5606 is difficult to harden in contact with sulfur, amine and tin materials .

Reliability test results

JOMS 5606 reliability test C6 results are as follows:

Storage and transportation

1. This product should be stored in a cool and dry environment below 25℃ , and the storage period of A/B

below 25℃ is 1 year.

2. Products exceeding the storage period should be tested and confirmed for abnormalities before use .

3. Such products are non-dangerous goods and can be transported as general chemicals. Be careful of leaks during transportation!

Product packaging

A: 1 kg/bottle, B:1 kg/bottle . 2kg/set

A: 10 kg/pot, B:10 kg/pot. 20 kg/set