Micro Capsule Epoxy Thread Locking Agent

JOM80 Micro Capsule Epoxy Thread Locking Agent

Product Description

JOM80  is  a powerful pre-applied adhesive film for locking and sealing. JOM80 is factory pre- applied  to  either  internal  or  external  threads.  It remains inert on the fastener until assembly of the threads mixes the resin. The resin fills the voids of the threads and cures to lock and seal the assembly.

Typical Applications

JOM80  prevents  loosening  through  vibration  to provide locking and  sealing of threaded assemblies including but not limited to:

• Ringgearbolts
• Head bolts
• Intake manifold bolts
• Transmissionbolts

Properties ofUncured Material

Chemical Type                  Microencapsulated Epoxy

Appearance                        Pink

Toxicity                             Low

Performance of Cured Material

Typical

Values

Installation Torque                                               < 1.0 N-m

Breakaway Torque                                                  30 N-m

Prevailing off-torque                                                8 N-m

k-Value                                                                           0.22

Temperature Range                                      -65◎F to 338◎F

(-54◎C to 170◎C) Cure time at 23°C                   72 Hours

Please    note    that    installation,    breakaway,    and prevailing   off-torque   data   are   from   test   results conducted  on  an  M-10  x  1.5  dry  phosphate  finish bolts and M010 x  1.5 zinc nuts.   Performance  may vary depending on fastener finish.

Environmental and Fluid Resistance

Please note that all environmental and fluid testing was  conducted  as  specified  in  GB/T13477.4-2002. Chemical   resistance   testing   was   conducted   at temperature for 168 hours; parts were cooled to room temperature prior to testing.  High temperature aging was  conducted  for  500  hours  at  temperature; parts were  cooled  to  room  temperature  prior  to  testing. The percent of initial strength reported is based upon data collected for M-10 x 1.5 zinc organic finish bolts and M-10 x 1.5 zinc nuts.

General Information

Storage

Fasteners coated with product have a shelf life of 2 years  when   stored  in  a   cool  and  dry  location  at temperatures   between    – 10°C   to    35°C.   Optimal storage is 25±4°C.

Packaging sizes: 2 kg, 5 kg, 19 kg

Storage conditions: 4–38℃, dry and cool place.

In practical applications, solvents may be used to dilute the product as required by the process. Before dilution test the original adhesive.

Special Note:

The data in this manual was obtained under laboratory conditions. Due to variations in operating environments , users  should refer to these data  and usage conditions  for analysis and testing. If users encounter any issues during use, please contact JOME’s Technical Service Department, and we will provide full assistance.